Pedestrian struck by vehicle or object propelled by another vehicle in nonroadway area · Concussions
At a glance
Federal OSHA recorded a severe workplace injury
at Keystone Consolidated Industries, Inc., 7000 S Adams St, PEORIA, ILLINOIS 61641
on — Concussions, affecting the Brain.
Final narrative
An employee was helping stack scrap wire. A fork truck was setting a carrier of scrap wire on top of another carrier. The scrap wire on the fork truck caught on the second carrier, and the carrier on the forks was pulled off. It struck the employee in the head, causing a concussion. The employee was hospitalized.
Hospitalized Brain Forklift, order picker, platform truck powered
More severe injuries at Keystone Consolidated Industries, Inc.
An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.
On July 7, 2025, at approximately 1:45 AM, an employee was moving vermiculite in a zinc pan with shovel. Molten zinc entered his left boot and caused burns to his shin and the top of his foot.
An employee was setting a floor plate on strand #2 while a rod in strand #1 cobbled at the break-out box and struck the employee's right foot. The employee sustained a puncture to their foot requiring surgery.
An employee was stringing wire around a drawing block at a wire machine. His left hand became caught between the wire and the drawing block, and he suffered an amputation to the ring fingertip.
On December 6, 2023, an employee's right hand was on the hinged side of a door jamb when the door closed, resulting in a partial amputation and a fracture to the right little fingertip.
The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was helping offload an aircraft. She was standing in the opening between a parked cart and an unoccupied aircraft tug when another vehicle struck a stationary bag cart, which then struck her. The employee suffered a skull fracture near the right eye, a right kneecap fracture, a nose fracture, and sinus damage, as well as soft tissue damage to the left calf and hip. She was hospitalized and required surgery.
An employee was cutting steel channels from a hanging rack that was being supported by a forklift. When they were finished, the forklift started moving the rack out of the area and a piece of material snagged one of the rack legs, causing the rack to tilt backward. The rack slipped off the forklift and struck the employee on his right side/lower back. He sustained a fractured pelvis and was hospitalized.
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
More severe injuries in this industry (NAICS 331110)
An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.
An employee was working to close a furnace door. The hydraulic mechanism that opens and closes the furnace door was non-operational and had been disconnected to allow the furnace door to be opened manually. As the employee was releasing the pins that held the door open, the door and the hydraulic cylinder fell, pinching their left hand between the hydraulic cylinder's base plate and the furnace. The employee suffered amputation of the little fingertip.
A rolling mill was shut down due to a cobble between two mill stands. The injured employee was cleaning the cobble from the delivery side of stand A, while another employee went to the control panel to move stand B and stand A moved instead. The injured employee's right thumb got caught between the delivery guide of stand A and the looper trough. The tip of his thumb required surgical amputation to the bone to allow for stitches.
An employee was helping another employee load stock material onto a press brake when the stock slipped. The injured employee's right index finger was caught between the press brake die and the stock, resulting in amputation at the first knuckle.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.