Struck by other propelled object or substance n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at MOHAWK INDUSTRIES, INC., 106 John Bankson Dr., SUMMERVILLE, GEORGIA 30747
on — Fractures , affecting the Ears and facial region unspecified.
Final narrative
An employee was cleaning/unjamming polymer that had hardened inside the pipe near the ball valve. As the employee was chipping it away with a pole, the ball valve that was in a locked-open position failed, released, and snapped close on the pole, causing the pole to jerk back and strike him in the face. The employee sustained a fracture to the face that required hospitalization.
Hospitalized Ears and facial region unspecified Tools, instruments, and equipment unspecified
On July 31, 2025, two employees were walking near a friction wash tank when a rubber gasket on top of the tank blew. Hot water mixed with 50% caustic chemical sprayed out and rained down on the employees. Both employees were brought to an emergency shower and were neutralized with vinegar. One employee was hospitalized with chemical and thermal burns to their upper back and eyes.
On December 29, 2024, at 1:30 PM, an employee was using a safety knife to move an object from the conveyor when it became stuck in a pinch point between two rolls of an extrusion machine. The employee's right hand was pulled into the machine, resulting in amputation of the hand.
On December 20, 2024, an employee was preparing to remove the access panel for the rotary valve gear box underneath a washer in polymerization. When he began loosening the bolts from the rotary lock cover, hot water and steam pressure released and caused second-degree burns to the employees stomach, both thighs, and the left calf area.
An employee was operating a press when the timing belt came loose. The machine was turned off. As the employee began to adjust the belt, the pulley on the table moved and his right middle finger was caught between the belt and pulley and amputated.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.
An employee was feeding boards into an edger. They fed a board in and then adjusted the blade for a second board that was wider. When they fed the second board into the edger, it hit the first board and kicked back, striking the employee in the chest. They sustained injuries including a spine fracture, an injured pancreas, as well as potential injuries to their spleen, liver, and intestine. The employee was hospitalized and required surgery.
An employee was helping an operator to pull a cable off a winch. The operator pulled in the line when it hooked some tree brush. The brush then whipped around and struck the employee's arm, resulting in a broken arm.
A co-worker was adjusting an overhead bracket with an impact wrench when the tool flew out of their hand and struck the injured employee in the face. The injured employee sustained an injury to their left eye.
More severe injuries in this industry (NAICS 314110)
On September 10, 2025, an employee was working to fix a slipping carpet on a conveyor. He went to lift the carpet and put it back on the top rail when the conveyor belt caught his right hand and a roller subsequently caught his arm. The employee was hospitalized with a broken forearm.
On July 31, 2025, two employees were walking near a friction wash tank when a rubber gasket on top of the tank blew. Hot water mixed with 50% caustic chemical sprayed out and rained down on the employees. Both employees were brought to an emergency shower and were neutralized with vinegar. One employee was hospitalized with chemical and thermal burns to their upper back and eyes.
On May 27, 2025, an employee had been sweeping the floor around the sort and grind line conveyor. She was wiping down the frame of the conveyor when her right arm was drawn up between the conveyor belt and the snub roller underneath the conveyor. She sustained fractures to her upper and lower arm.
On January 29, 2025, an employee was operating an extrusion machine. He put a broken piece of yarn on the secondary roller and his glove was pulled into the nip rollers. The employee's left little fingertip was partially amputated.
On December 20, 2024, an employee was preparing to remove the access panel for the rotary valve gear box underneath a washer in polymerization. When he began loosening the bolts from the rotary lock cover, hot water and steam pressure released and caused second-degree burns to the employees stomach, both thighs, and the left calf area.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.