MOHAWK INDUSTRIES, INC.

On July 31, 2025, two employees were walking near a friction wash tank when a rubber gasket on top of the tank blew. Hot water mixed with 50% caustic chemical sprayed out and rained down on the employees. Both employees were brought to an emergency shower and were neutralized with vinegar. One employee was hospitalized with chemical and thermal burns to their upper back and eyes.

On December 29, 2024, at 1:30 PM, an employee was using a safety knife to move an object from the conveyor when it became stuck in a pinch point between two rolls of an extrusion machine. The employee's right hand was pulled into the machine, resulting in amputation of the hand.

On December 20, 2024, an employee was preparing to remove the access panel for the rotary valve gear box underneath a washer in polymerization. When he began loosening the bolts from the rotary lock cover, hot water and steam pressure released and caused second-degree burns to the employees stomach, both thighs, and the left calf area.

An employee was operating a press when the timing belt came loose. The machine was turned off. As the employee began to adjust the belt, the pulley on the table moved and his right middle finger was caught between the belt and pulley and amputated.

On October 15, 2024, a utility employee was removing fiber from a drum on a 2-meter fiber line. The drum caught the employee's left thumb, resulting in a partial medical amputation at the first knuckle.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

An employee was operating a drill and tap machine. He was placing a part with his right hand and removing a part coming in on the left side. He saw a part that was crooked and went to straighten it. The machine clamped down on his left index finger, degloving the top part of the finger and resulting in a partial amputation.

An employee was performing maintenance on a roll cutting machine in a warehouse. The employee was removing excess grease from the bearings when the machine's chain caught their right index finger. The fingertip was amputated by the chain and sprocket.

During fiberglass work, an employee mixed a methyl ethyl ketone peroxide (MEKP) catalyst with a cobalt chemical that they thought was a dye. A chemical reaction occurred, resulting in an explosion. The employee sustained second-degree burns on his back and a blister on his right arm.

An employee was walking when she tripped over a box on the ground and fell. The employee was hospitalized with a severe dislocation to the hip and leg that required surgery.

An employee was cutting material on a straight saw when the blade lacerated her right index finger. The employee was hospitalized.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.