United Airlines Holdings, Inc.

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

An employee was clearing a jam on the airport baggage system conveyor when his left leg became caught between slats of the conveyor. The employee sustained fractures and tissue damage to his lower leg, requiring hospitalization and surgery.

An employee was helping offload an aircraft. She was standing in the opening between a parked cart and an unoccupied aircraft tug when another vehicle struck a stationary bag cart, which then struck her. The employee suffered a skull fracture near the right eye, a right kneecap fracture, a nose fracture, and sinus damage, as well as soft tissue damage to the left calf and hip. She was hospitalized and required surgery.

An employee was working to refuel a truck. While handling the fuel hose(s), she experienced pain in her stomach. After completing the task, the employee drove back to the pad and the movement aggravated her abdominal pain. The employee was hospitalized with an abdominal sprain/strain.

An employee was on a jetway overseeing the operation. As the jet bridge was retracted, the employee's left arm was caught between the jet bridge side walls. The employee sustained a degloving to their left forearm.

An employee was descending a fixed ladder on the side of a container loader. The employee fell from the ladder, landing on the ground about 6-8 feet below and sustained fractures to their back and pelvis.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.