Halo Services, Inc.

An employee was kneeling on a platform. He stood up, then fell off the platform to the ground 7 feet 10 inches below, suffering broken ribs.

An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was working on a production line. The employee went to retrieve parts that came out of the parts holder, and their left hand became caught between a chain and a sprocket. Three fingers on the hand were amputated.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a pad printer. The employee's finger was caught in the printer and they suffered a fingertip amputation. The part of the printer that caught the employee's finger was unguarded at the time.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee fell while stepping off the tailgate of a pickup truck. The employee landed on the ground and suffered a broken left fibula and tibia.

On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.

Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.

An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.

An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.

On 7/31/2025, an employee was training to ride an ATV when it went into a draw and she went over the front of the ATV, landing on the ground. The employee sustained a fractured arm.

An employee was standing behind a frac pump. A discharge hose failed and the employee was burned by hot water on the left upper abdomen. The employee was hospitalized.

An employee working as a contracted firefighter was using a bulldozer to push back an active fire line when they became entrapped in flames, resulting in first- and second-degree burns.

An employee was assisting with the delivery of pipe racks to the drilling rig. The driver was releasing the tie-down lock straps that were holding the pipe racks on the trailer. When the last strap was released, one of the pipe racks rolled off the trailer and struck the employee while they were on the passenger side of the trailer bed. The employee sustained an open wound to the hand and fractures to their left leg and spine.