Ignition of clothing · Thermal burns third degree or higher
At a glance
Federal OSHA recorded a severe workplace injury
at Keller North America, Inc., 17805 Volbrecht Road, LANSING, ILLINOIS 60438
on — Thermal burns third degree or higher, affecting the Knee(s) and leg(s).
Final narrative
On October 16, 2024, at approximately 10:00 a.m., a welder bent over to pick up a pair of gloves when a propane heater ignited the employee's clothing, causing third-degree burns to the back of the employee's right leg and knee.
Hospitalized Knee(s) and leg(s) Clothing
More severe injuries at Keller North America, Inc.
An employee got into a physical altercation with another employee at the job site and he sustained a fractured jaw. He was hospitalized and required surgery.
An employee was setting a steel reinforcing cage in an auger cast pile and removing synthetic rigging straps off of the vertical bars. Their right hand became caught between the rigging strap and the auger cast pile, resulting in hospitalization with an amputated little finger.
An employee was inside of an excavation assisting in drilling operations when their left foot was pinched between the drill rig's jaw table and a retention wall. They sustained a fracture to their heel bone that required surgery.
An employee was moving steel beams from the lay down area to the welding area when a sheet hand slid, catching his right middle finger between it and the flange of a steel beam. The employee's right middle fingertip was amputated.
A crew was using a crane to assemble another crane when an employee tripped over an incline and lost his balance. The employee fell 6-7 feet from the decking to the asphalt surface below, resulting in fractures of the right arm above the elbow and left wrist. The employee also experienced swelling to the top of the left foot.
After repairing a piece of industrial equipment, an employee had brake-cleaning liquid on his gloves. A lighter ignited the liquid, and the employee's hands were severely burned.
An employee was cleaning a seam with weather membrane cleaner. The cleaner soaked into the employee's gloves, and they caught fire when a cigarette was lit. The employee suffered first- and second-degree burns to both hands and was hospitalized.
The injured employee had been working with xylene in a paint booth and exited the paint booth for a smoke break. The employee dropped his lighter, causing his clothing to catch fire, possibly from xylene vapors. The employee sustained burns from their chest down to their thighs and was hospitalized.
An employee was charging the furnace when a spark from the furnace ignited and struck the employee's undershirt. The employee sustained burns to their lower back, hands, and front abdomen.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.