Fall on same level n.e.c. · Multiple surface and flesh wounds
At a glance
Federal OSHA recorded a severe workplace injury
at BHD Storage Solutions, Inc., 140 Mendel Drive SW, ATLANTA, GEORGIA 30336
on — Multiple surface and flesh wounds, affecting the Other multiple ear(s), facial locations.
Watch BHD Storage Solutions, Inc. — freeGet an email when a new federal OSHA severe-injury report for BHD Storage Solutions, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
On March 21, 2025, an employee working in the dispatch area was walking from the parking lot toward the warehouse when he lost balance and fell face down onto a concrete ramp. The employee sustained a laceration to the forehead, and two teeth were broken. The employee was hospitalized.
Hospitalized Other multiple ear(s), facial locations Other constructed surface
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.
An employee was talking to a child on the playground, when the child grabbed her hand to lead her away. The employee stepped, lost her balance, and fell over. The employee was hospitalized with a fracture of her lower left leg and required surgery.
An employee was lowering a safe stack beam inside a trailer. The beam released, causing the employee to fall back and strike his head on the trailer floor. He was hospitalized with a brain bleed and a concussion.
An employee was on the ground working to close a trailer door. The door was caught by the wind and blew the employee backward. He landed on his back and sustained four fractured ribs, requiring hospitalization.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.
A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.
An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.
A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.