Granby Industries Transport USA LLC

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.

Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.

A truck driver was preparing a hose to load a chemical tanker trailer with sulfuric acid when sulfuric acid splashed the left side of their face and neck, causing skin burns.

An employee was disconnecting steam lines from a bulk liquid trailer. He disconnected a steam line located on a vapor recovery line when hot steam blew back onto him, resulting in burns to the left side of his abdomen, as well as his left arm and leg. The employee was hospitalized.

An employee was driving a truck when it lost power. He pulled over, opened the hood, checked the engine, and opened the radiator cap. Pressure in the radiator caused hot fluid to spew over the employee, who suffered second-degree burns to the left arm, hand, and leg.

An employee was pulling apart pallets that were stuck together when they felt pain in their stomach. The employee was hospitalized with a hernia.

An employee was getting out of a truck tractor when he fell to the ground. He suffered a broken left femur.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.