Struck by rolling, sliding, or shifting objects non-running · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Perfection Architectural Systems, LLC, 238 Grande Ave., CORAL GABLES, FLORIDA 33133
on — Amputations, avulsions, enucleations unspecified, affecting the Other finger(s) n.e.c..
Final narrative
An employee was closing the gate on a fence at the jobsite when their finger became caught in the track roller on the gate. The employee sustained an amputation.
An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.
An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333992)
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
An employee was at the loading dock working to manually move an oversized load off of a pallet that was sitting on another pallet. The oversized load (a gas cylinder cradle) tipped over and crushed the employee's right leg against the ground. The employee sustained a fracture to their ankle/leg requiring surgery.
An employee was depressurizing a line stop actuator when their left arm was struck by a threaded, 2-inch nipple from the side of the line stop housing. The employee sustained fractures to their left arm and a rib.
An employee was cutting the top of an empty scrap barrel that previously contained antifreeze. The bottom of the barrel blew out due to pressure that built up and caused his jeans to catch fire, resulting in burns.
An employee was moving extra wire out of a cleaning tank by using the tank's jogging function. Two of the employee's right-hand fingers were caught on the last strand going around the acid roll, and the employee suffered an amputation to the right little fingertip.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.