Struck by rolling, sliding, or shifting objects non-running · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Delta Steel, 1548 Edgefield Way, CEDAR HILL, TEXAS 75104
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was separating a bundle of steel channel using a lifting device. While the employee was inserting a piece of wood dunnage between the pieces of material, the load shifted. This caused the steel channel to come down and pinch the employee's index finger, leading to a partial amputation of the fingertip.
Amputation Finger or thumb tip(s), nail(s) Beams and rails metal
An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.
An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.
An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 331210)
An employee was cutting wooden boards using a table saw when the glove on his left hand was caught by the blade, resulting in a partial fingertip amputation.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
A crane was hoisting a pipe. An employee was adjusting twisted lifting chains on the end of the pipe when the pipe was raised, causing the employee's hands to be caught between the chains and the pipe. The employee suffered injuries to the left index finger, left ring finger, right ring finger, and right index finger; the right index fingertip was amputated without bone loss.
During a routine inspection, an employee placed their hand on a pipe to check a weld. The pipe clamp activated, closed on the pipe, and trapped the employee's right middle finger, resulting in a partial amputation and fracture to the fingertip as well as a laceration to the ring finger.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.