Engineered Exhaust Systems / B-T, Inc..

An employee was operating a sit-down type of material handling equipment (MHE). They were turning the MHE with the clamp attachment in the air when the MHE fell over onto its right side. The employee's right foot was caught under the battery cover of the MHE. The employee sustained a chemical burn from the battery and a fractured right ankle.

An employee was driving a snowmobile when it flipped over. The employee suffered a broken rib.

An employee was driving an unloaded forklift outside a building. During a left turn, the forklift drove off the paved area onto an unpaved surface, became unstable, and tipped over. The employee was pinned under the forklift and suffered two broken leg bones and a broken hip.

An employee was riding in a utility task vehicle when it overturned. The employee sustained a broken leg.

An employee was trimming tree branches from an aerial lift. As they were maneuvering the aerial bucket lift from inside, the truck drove over soft ground and tipped over. The bucket lift fell to the ground with the employee tied off inside, resulting in rib fractures.

An employee had been utilizing a lift assist for assembly. When assembly was complete, the lift assist was hung on a rack behind the employee and it became energized because the trigger got caught. When the employee reached for the lift assist, it sprung up, striking their face. The employee was hospitalized with a facial fracture(s) and a concussion.

An employee inspected a machine to see if water leaking from the roof was affecting it and covered the machine with plastic. The employee was descending a 6-foot A-frame ladder when they slipped and fell to the ground from the third or fourth rung from the bottom. The employee sustained a fractured left humerus.

An employee was running a steel blanking press. After hearing a rattling noise in a conveyor belt that handled scrap coming out of the press, the employee went to clear a jam on the belt. The belt caught the employee's glove, and the employee's index and middle fingers were amputated.

An employee was operating a cone/spear punch press and went to remove a metal piece when the machine cycled. His thumb got caught between the cut rear section of the converter and the internal parts remaining inside and was crushed. The employee was hospitalized.

An employee was loading a coil of steel into the feeder for a 200-ton steel press when it actuated and his hand became caught in the feed rollers. The employee sustained lacerations and a fracture to his left forearm.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.