KIEWIT OFFSHORE SERVICES LTD

An employee was driving a utility task vehicle (UTV) when it struck a load of steel angle iron that was resting on forklift forks, resulting in facial fractures.

At about 9:15 a.m. on May 22, 2023, an employee was using a 5-pound hammer to remove the weld on a pipe support and knock the support lose. The hammer missed the support; the employee's left index finger struck the support and was lacerated and broken. The fingertip was medically amputated.

At the end of their shift, a shuttle lift (gantry crane) operator was descending the shuttle lift via the equipment ladder. While stepping from the third to last rung, the employee missed their footing and fell approximately 3 feet onto metal plates, landing in a sitting position. The employee sustained a fractured lumbar vertebra.

An employee was inspecting the welds on a 10-inch pipe. A 24-inch pipe next to the 10-inch pipe rolled off a piece of dunnage while the employee was passing over it, causing the employee to strike the 10-inch pipe with his right side. He suffered a kidney injury and was hospitalized.

An employee was bitten on the right index finger by a poisonous snake and hospitalized.

An employee was walking along a trench inspecting the trench box in the excavation when he tripped and fell toward the trench. As the employee was falling head-first into the trench, he attempted to get a hold of the fall protection cable. The cable then looped around his left hand and the employee fell approximately 8 feet into the trench before the fall protection engaged. The employee suffered amputations of his left index, middle, ring, and little fingers.

A ranger was performing back-country patrol duties while hiking. As they were climbing a technical rock patch, a rock handhold broke, causing the employee to fall approximately 15 feet before their belay engaged. The employee contacted a rock, resulting in a fracture to the right ilium as well as a subcutaneous hematoma to the right gluteal region.

Employees were erecting structural steel. The injured employee was sitting on a 12" wide horizontal member and lining up an I-beam brace as it was suspended by an overhead crane. He leaned left to push the end of the brace. The end of the suspended brace swung away from him, causing him to lose balance and fall 8 feet. His personal fall arrest system arrested his fall, but he swung into a piece of duct work during the fall that resulted in a concussion.

On September 12, 2022, an employee was on a metal roof, installing a standing seam and insulation. He lost his balance and fell toward the third floor slab, which was 10 feet from the roof. His fall protection caught him and left him suspended about 2 to 4 feet from the slab. He suffered a brain bleed and a spinal fracture in his lower back. He was hospitalized.

An employee was working from a bucket lift, removing a tree in sections. He lost his balance while pushing on a section and fell. His fall protection caught him and he swung into a tree, suffering an injury that caused head, neck, and leg pain, as well as loss of consciousness while he was at the hospital.

An employee was acting as a spotter for a forklift operator. While its forks were being raised, the forklift came into contact with a power line. The employee was touching the forklift's metal frame at the time and was shocked on the left palm. The employee suffered burns to both the left palm and the sole of the left foot.

An employee was leaning down to install conduit. When he stood up, a 2-inch all-thread rod caught and lacerated his left eyelid.

An employee was working as a fire watch. The employee was exposed to anhydrous ammonia and was not able to see while climbing down a ladder due to eye irritation. The employee fell and was hospitalized for a broken ankle.

An employee was standing on the ground awaiting the lowering of a pipe. After the pipe was lowered to the ground by a skid steer, it rolled and struck the employee's left leg. The employee was hospitalized with a fractured leg.

An employee was tightening a gas pipe with a wrench when the wrench slipped from his hand. The employee's arm then hit a metal cross-brace, resulting in a lacerated arm.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.