105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Limoges Construction, Inc.

Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified

Federal OSHA recorded a severe workplace injury at Limoges Construction, Inc., 1121 North Covell Avenue, SIOUX FALLS, SOUTH DAKOTA 57104 on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..

An employee was cutting rebar with a cut-off saw when the employee's clothing caught fire, causing burns to approximately 70% of the employee's body.

Hospitalized Multiple body parts, n.e.c. Clothing, unspecified

Limoges Construction, Inc.

An employee was shearing rebar to different lengths. The rebar shear's hold-down clamp crushed the employee's right hand.

Limoges Construction, Inc.

An employee was guiding a concrete power trowel into the back of a pickup truck. The trowel was being lifted by a chain attached to a forklift. As the trowel was being lowered into the pickup truck by the forklift, the employee's right ring finger was pinched between the trowel handle and the side of the pickup truck bed, resulting in an amputation with no bone loss.

Limoges Construction, Inc.

An employee was attempting to hook up a ground heater to a truck, but the trailer wasn't hooking up properly. His finger was between the ball hitch and receiver when the trailer dropped onto the hitch, pinching his left ring finger. His fingertip was amputated.

View Limoges Construction, Inc.'s full OSHA safety record →

Falls Manufacturing Company/a U-Haul Co.

An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.

Flint Ag & Turf

An employee was using a small propane heater when they sustained third-degree burns to the left buttock and second-degree burns to the back and neck.

Novae, LLC.

An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.

Pik Rite Inc.

An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.

DC Power Tong, LLC

An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.

WADDELL CONCRETE INC.

An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.

BRUNDAGE-BONE CONCRETE PUMPING, INC.

An employee was changing a boom pipe delivery system on a concrete pump truck. He tripped and fell from an elevated level to the ground, resulting in multiple leg fractures.

Kansas Paving / Kansas Ready Mix

An employee was reading numbers off a belt that feeds a plant. He reached his hand up and the belt caught his finger, resulting in a finger amputation.

Paul Conard Construction Co., Inc

An employee was guiding the pouring end of a concrete pump truck's boom while standing on top of 4-foot wall forms. The boom contacted power lines and the employee was shocked. The employee sustained third-degree burns on the entry and exit path of the electricity, and also sustained first- and second-degree burns to their torso and legs.

Mid Illinois Concrete & Excavation, Inc.

An employee was holding a form board on a section of pavement. A skid steer backed into the employee's ankle, breaking it. The employee was hospitalized.

Simon Contractors of South Dakota, Inc.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

Agtegra Cooperative

An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.

Martin Brower Distribution Center

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

Mayfield Truss, LLC

An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.