Evergy

Employees were setting a pole along a county road to replace a storm-damaged pole. They were positioning the new pole in the hole and were canting the new pole using the pole chain. The pole shifted and dropped in the hole, causing the chain to roll over an employee's right index finger. The chain caught their finger against the pole and resulted in a fingertip amputation without bone loss.

An employee was utilizing an aerial bucket to repair the service drop at a residential home. The truck that the arial bucket is attached to was parked on a slope and began to move. The employee was ejected from the bucket and landed on the ground, sustaining two back fractures.

An employee was using a drill with a ground rod attached to wind up a line to pull a flat mule line from transformer to transformer. His left little finger became wrapped in the line and was partially amputated.

An employee was working on a pad-mounted transformer when he suffered a 7,200-volt shock. He was hospitalized.

An employee was carrying out a meter test on the side of a pad-mounted transformer. An arc flash burned the employee's face and hands. The employee was hospitalized.

An employee was fixing ceiling tiles while working from a ladder when they fell to the floor and sustained a hip fracture.

An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.

An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.

An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.

An employee was coming down a portable ladder when they slipped and fell to the ground, resulting in a right forearm fracture.

An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.

An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.

An employee was working to move a telephone pole when the pole rolled, causing injury to their hip.

An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.

An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.