Direct exposure to electricity, unspecified · Electrical burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at EVERGY, 1650 State Highway B, LIBERTY, MISSOURI 64068
on — Electrical burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
Two employees were attaching a tie-in wire to hold a wire to a new insulator that had been put on a pole. The tie ware came into contact with the pole grounding wire, causing an arc flash that burned the employees' faces, arms, and necks.
HospitalizedMultiple body parts, n.e.c.Power lines, transformers, convertors
Employees were setting a pole along a county road to replace a storm-damaged pole. They were positioning the new pole in the hole and were canting the new pole using the pole chain. The pole shifted and dropped in the hole, causing the chain to roll over an employee's right index finger. The chain caught their finger against the pole and resulted in a fingertip amputation without bone loss.
An employee was utilizing an aerial bucket to repair the service drop at a residential home. The truck that the arial bucket is attached to was parked on a slope and began to move. The employee was ejected from the bucket and landed on the ground, sustaining two back fractures.
An employee was using a drill with a ground rod attached to wind up a line to pull a flat mule line from transformer to transformer. His left little finger became wrapped in the line and was partially amputated.
An employee was carrying out a meter test on the side of a pad-mounted transformer. An arc flash burned the employee's face and hands. The employee was hospitalized.
An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.
An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.
An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.
An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.
On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.