Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Seal Proof Corporation, 36 Old Kings Highway, DARIEN, CONNECTICUT 06820
on — Heat (thermal) burns, unspecified, affecting the multiple trunk locations.
Watch Seal Proof Corporation — freeGet an email when a new federal OSHA severe-injury report for Seal Proof Corporation is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was cleaning and drying substrate. While he was using a hand-held propane torch to dry the substrate, his pants and lower shirt caught fire. He suffered burns to the lower back and buttocks.
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 238390)
An employee was using a 10-foot step ladder to install roller shades. The employee fell from the third rung from the top, landing on the ground and suffering back and head injuries. The employee was hospitalized.
While on a scaffold, an employee was transporting heated sealant material in a bucket. The employee tripped and fell, causing the heated material to splash onto his gloved hands. The employee sustained second-degree burns to both hands and his right wrist.
Three employees were pulling tension cable (similar to rebar) through the walls of a condo using a motor system. Two employees were needed to hold the cable while the third employee drilled the mounting locations. When the third employee activated the drill, the cables twisted. They caught the right index finger of one of the other two employees, amputating his fingertip.
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.