Fall on same level due to tripping, n.e.c. · Bruises, contusions
At a glance
Federal OSHA recorded a severe workplace injury
at Spirit Aerosystems, Inc., 3801 South Oliver, WICHITA, KANSAS 67210
on — Bruises, contusions, affecting the chest, except internal location of diseases or disorders.
Final narrative
An employee was cleaning the upper area of an aircraft fuselage with a pneumatic vacuum. When the employee stepped on the corner of a floorboard, it tipped, causing the employee to lose his balance and fall on the same level. He suffered a contusion to the left-side ribs.
HospitalizedChest, except internal location of diseases or disordersFloor irregularity
A metal tooling base was being moved by a forklift when the load shifted. An employee who was assisting went to stabilize the load and prevent it from sliding off the forks. The C-channel of the base crushed the employee's left hand against the concrete ground, resulting in the amputation of their third and fourth fingers.
An employee was working on a tool platform (47.5" tall) and was transitioning around to the other side when they lost balance and fell to the concrete floor. The employee was hospitalized with fractures to seven ribs and their elbow.
An employee was working inside the access panel of a sliding door when the door began to shut. The employee's left middle finger was pulled into the chain and sprocket, resulting in amputation to the middle knuckle.
An employee was installing a rail on a machine. The roller pack was locked up, causing the chuck to not move. While manually removing the chuck, the rails were damaged. As a result, both the roller pack and the rail needed to be replaced. A fixed magnet from above the rail pulled the rail up and rolled it, pinching the employee's thumb between the rail and the magnet when he tried to install the new rail back to the position. The right thumb tip was amputated.
An employee was walking down the metal stairs from the palletizing room when he fell backward onto the steps. He sustained two left rib fractures that required hospitalization.
An employee was removing T-posts from the ground when he tripped and fell on his left arm, resulting in an elbow fracture that required hospitalization.
An employee was stepping out of or into a vehicle when their foot became stuck between the curb and the vehicle, causing the employee to fall and sustain an ankle fracture.
An employee fell to the floor when her shoelace was caught on a drawer near her desk. The employee was hospitalized; she sustained a non-displaced femoral neck injury.
An employee was setting up for an event and carrying gates downhill. As the employee side-stepped down the slope, their right leg became caught in the compacted snow. The employee's momentum continued forward and their right leg remained fixed in the snow, causing fractures of the right tibia and fibula.
More severe injuries in this industry (NAICS 336413)
An employee was walking from one building to another when he slipped on wet concrete and fell. The employee was hospitalized with a fracture and dislocation of the right patella.
An employee was working inside the access panel of a sliding door when the door began to shut. The employee's left middle finger was pulled into the chain and sprocket, resulting in amputation to the middle knuckle.
An employee was installing a rail on a machine. The roller pack was locked up, causing the chuck to not move. While manually removing the chuck, the rails were damaged. As a result, both the roller pack and the rail needed to be replaced. A fixed magnet from above the rail pulled the rail up and rolled it, pinching the employee's thumb between the rail and the magnet when he tried to install the new rail back to the position. The right thumb tip was amputated.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.