Halliday Products, Inc.

An employee was bending bars when their fingers were caught in rollers and amputated.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.

An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.

An employee was grinding raw couplings on a belt sander to shave off excess material left by the manufacturing process. The employee's right hand slipped while he was pressing a part to the sander, causing his right thumb to come into contact with the sanding belt. The thumb was lacerated and broken, and the employee was hospitalized, requiring surgery.

An employee was buffing a corner casting when the rotating belt contacted her right hand, resulting in an amputation of the first segment of her right thumb.

An employee was assembling boilers, which involved stacking the flat sections of boilers on top of one another and pushing them down a non-powered roller line. While the employee was pushing a stack onto the next set of rollers, the stack became crooked. The employee went to pull back the stack to straighten it when their finger was pinched by a roller. The employee sustained a partial amputation to their left ring fingertip.

An employee was operating a projection welding press when the weld bit contacted her left hand, causing an amputation of the index fingertip.

On June 25, 2025, at 7.30 a.m., an employee was using a remote-controlled crane to change a die in a 2,600-ton press. They were releasing crane cables from the die when one cable did not release, causing the die to lift and pin the employee between the press and the die. The employee suffered a closed non-displaced fracture of the pelvis.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.