Atlantic Plant Maintenance, Inc.

Employees were removing hydrogen seal casing using a c-beam to rig it out of its position. The work group had the seal free and floating while attempting to prevent it from being damaged. The c-beam made contact with the end shield without the employees realizing it. They verbally gave a crane operator the signal to cable down, and when he did, the seal came toward the group with more force than expected. The seal casing hit one employee's right hand on his little finger, resulting in a fingertip amputation.

On October 4, 2021, at 8:20 a.m., two employees were using a hand pallet jack to move a trash dumpster to a crane bay. At the base of the trash hopper, there are two slots and a skid that allow a forklift to move the dumpster. Between the slots is a small metal pedal that allows the dumpster to slide forward. The employees attempted to insert the pallet jack under the skid, but the metal pedal was obstructing the forks of the pallet jack. Employee 1 reached down to lift and hold the pedal into position as Employee 2 inserted the forks. The forks pinched Employee 1's left middle finger, resulting in a fingertip amputation.

An employee was moving a cart with a grey board on it. Due to shifting of the cart or a wheel catching on an obstruction, the cart tipped over and struck two employees. One employee sustained a laceration on his arm requiring hospitalization.

An employee was standing on a pipe one foot off the ground when the employee fell, breaking the right arm.

While cutting wood on a table saw, an employee sustained a laceration from the left index fingertip down to the palm of the hand, requiring hospitalization.

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was moving metal out of a cart. He had removed one piece and was working to move another when the metal shifted. His right ring finger was crushed between the two pieces, and he suffered a partial amputation to the finger pad at the tip.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

Employees were replacing a 24" pig trap door. A strap was shackled on the pig trap door and connected to a forklift. Welders began to cut the door off. An employee was holding onto the door when the cut was finished. The door shifted and caught his fingers, resulting in a hand injury and amputation.

An employee used a crane to set down a bar. The bar measured 9 inches by 16 feet. The strap got stuck under the bar, and the employee asked another employee to jog the roll. The bar rolled and pinched the injured employee's left hand, resulting in a fingertip amputation.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.

An employee tripped while stepping over a hose, fell on the ground, and dislocated his shoulder. He was hospitalized.

An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.

On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.

An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.