AURORA, COLORADO—
A-1 Chipseal & Rocky Mountain Pavement
Contact with hot objects or substances · Thermal burns third degree or higher
At a glance
Federal OSHA recorded a severe workplace injury at A-1 Chipseal & Rocky Mountain Pavement, 3358 S. Laredo, AURORA, COLORADO 80010 on — Thermal burns third degree or higher, affecting the Multiple body parts n.e.c..
Final narrative
An employee was repairing asphalt cracks on the street using a wand to spray hot rubber material to repair the cracks when it sprayed rubber material onto the employee resulting in second- and third-degree burns to her face, neck, and arm.
Similar incidents · Same event type
NEW YORK, NEW YORK—
Spudrock LLC
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
AKRON, OHIO—
Ajinomoto Health and Nutrition North America Inc.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
JACKSON, ALABAMA—
APAC-Alabama, Inc.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
KEARNEY, NEBRASKA—
Cellar Crew LLC
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
HAVANA, FLORIDA—
Boise Cascade Wood Products, LLC
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 324121)
METHUEN, MASSACHUSETTS—
Cassidy Corporation
An employee was stopping traffic at a job site so a piece of equipment could be moved to another location when he was struck by a car. It sent him in the air and he landed on his back, resulting in hospitalization with five fractured ribs, a fractured forearm, and a liver injury.
LAREDO, TEXAS—
Anderson Columbia Co., Inc.
A truck of asphalt binder was being unloaded. An employee was checking the transfer hose connection on the truck. The gasket on the hose blew out, causing the asphalt binder to shoot out and burn the employee's face, neck, and arms.
LAKE BLUFF, ILLINOIS—
Chicagoland Paving Contractors, Inc.
A truck driver was on a platform, pulling a tarp on an asphalt load in a six-wheel dump truck. He fell from the platform to the ground and suffered broken ribs.
ITALY, TEXAS—
AA Biggs & Holdings, LLC
An employee was using a cutting torch to heat up bolts that had seized up. The bolts caught on fire in a flash burn, and the employee suffered burns to the arms and elbows.
CHELSEA, MASSACHUSETTS—
BROX INDUSTRIES, INC.
On May 15, 2025, an employee was cutting down steel mesh and debris that was protruding from a milled roadway. As the employee began to cut a piece of steel with an angle grinder, he steadied himself with his left hand and the tool contacted the top of his left wrist, resulting in a laceration that required hospitalization.
More severe injuries in COLORADO
GREELEY, COLORADO—
ABC Supply Company
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
BOULDER, COLORADO—
Burke Builders Inc
An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.
LONGMONT, COLORADO—
Circle Graphics, Inc.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
DENVER, COLORADO—
FLATIRON CONSTRUCTION CORP.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
BURLINGTON, COLORADO—
Takkion OPS Management
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.