Other fall to lower level less than 6 feet · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Lockheed Martin, 86 South Cobb Drive, MARIETTA, GEORGIA 30063
on — Soreness, pain, hurt-nonspecified injury, affecting the head and neck.
Final narrative
An employee was sanding the top of the wing of a C-130. Another employee noticed his eyes rolled back as he appeared to lose consciousness. The employee fell approximately 2 feet from the top of the wing to the wing stand resulting in injuries to the employee's face and throat that required surgery.
HospitalizedHead and neckAirplane-powered fixed wing, n.e.c
An employee was troubleshooting a dust collector when they sustained partial amputations to three of their right fingertips from the spinning rotor of the motor.
On June 27, 2023, at 2:30 p.m., a pilot was returning after a test flight of an F-35 aircraft. After aircraft recovery, the pilot exited the aircraft via the integrally mounted aircraft access ladder. During his descent, he tripped on the third ladder step and fell approximately 6 feet, resulting in a dislocated left shoulder, a compound dislocation of the left elbow, and stable fractures of the left 7th and 8th ribs.
An employee was using a clutch spreader tool during a training activity. When he applied pressure to the tool to release belt pressure, his left index finger came in contact with a spring sheave roller. The finger was amputated just below the nail.
A 370-pound piece of aluminum was being lifted with a jib crane and a calibrated suction lifting fixture. The aluminum fell, landing on an employee's left foot about 3 feet below. He was hospitalized; his big toe had been broken, and the other four toes were medically amputated.
An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.
An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.
An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.
An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.
An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.
More severe injuries in this industry (NAICS 336411)
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
A metal tooling base was being moved by a forklift when the load shifted. An employee who was assisting went to stabilize the load and prevent it from sliding off the forks. The C-channel of the base crushed the employee's left hand against the concrete ground, resulting in the amputation of their third and fourth fingers.
An employee was working on a tool platform (47.5" tall) and was transitioning around to the other side when they lost balance and fell to the concrete floor. The employee was hospitalized with fractures to seven ribs and their elbow.
On August 19, 2025, at 6:30 a.m., an employee sat in the rear bench seat of a golf cart ahead of being driven to a parking lot. When the golf cart began to move, he fell off the cart and onto the ground, resulting in a fractured right hip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.