WICHITA, KANSAS—
Textron Aviation
Other fall to lower level 6 to 10 feet · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury at Textron Aviation, 10511 E Central, WICHITA, KANSAS 67206 on — Soreness, pain, hurt-nonspecified injury, affecting the multiple trunk locations.
Final narrative
An employee was about to install a panel on the left wing of an aircraft when the panel started to slip. As he tried to stop it from falling, he lost his balance and fell about 8 feet, hitting part of the engine and then the ground below. He injured his lower back and ribs.
More severe injuries at Textron Aviation
WICHITA, KANSAS—
Textron Aviation
An employee was working to remove product from an 800-ton skin stretch. The employee lost his footing and fell approximately 15 feet from a platform into a safety net in the pit under the stretch operating area. The employee sustained a fracture to the C-7 vertebra.
WICHITA, KANSAS—
Textron Aviation
While running wood through a jointer, an employee's right ring fingertip was partially amputated by the jointer's blade.
INDEPENDENCE, KANSAS—
Textron Aviation
While using a hand held 1/4" drill the injured employee's glove became entangled in the rotary file bit resulting in the amputation of a fingertip.
WICHITA, KANSAS—
Textron Aviation
An employee was using a router machine and got caught between two tables on the router machine resulting in a pelvic injury.
WICHITA, KANSAS—
Textron Aviation
A maintenance employee was troubleshooting an automatic tool changer (ATC) on a lathe. The employee thought the ATC was stopped when he stuck his hand in to check the alignment. At that point, the ATC cycled, nipping the tip of his left 2nd finger.
View Textron Aviation's full OSHA safety record →
Similar incidents · Same event type
BATON ROUGE, LOUISIANA—
Petroleum Service Corporation
An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.
COVINGTON, GEORGIA—
Absolics Inc.
An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.
LAKELAND, FLORIDA—
American Residential Products, Inc.
Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.
PEN ARGYL, PENNSYLVANIA—
Berkheimer Maintenance
An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.
TIPP CITY, OHIO—
High-Tec Industrial Services, Inc.
An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.
More severe injuries in this industry (NAICS 336411)
ORLANDO, FLORIDA—
Textron Aviation Inc. (Orlando Service Center)
A pressurized aircraft nose landing gear strut assembly was being disassembled. The gland nut dislodged under pressure and made contact with an employee's left hand, breaking it.
WICHITA, KANSAS—
Spirit Aerosystems, Inc
A metal tooling base was being moved by a forklift when the load shifted. An employee who was assisting went to stabilize the load and prevent it from sliding off the forks. The C-channel of the base crushed the employee's left hand against the concrete ground, resulting in the amputation of their third and fourth fingers.
WICHITA, KANSAS—
Spirit Aerosystems Inc.
An employee was working on a tool platform (47.5" tall) and was transitioning around to the other side when they lost balance and fell to the concrete floor. The employee was hospitalized with fractures to seven ribs and their elbow.
PALMDALE, CALIFORNIA—
Northrop Grumman Corporation
An employee was adjusting the task lighting on a band saw when their right little finger made contact with the blade, resulting in amputation.
PALMDALE, CALIFORNIA—
Northrop Grumman Corporation
On August 19, 2025, at 6:30 a.m., an employee sat in the rear bench seat of a golf cart ahead of being driven to a parking lot. When the golf cart began to move, he fell off the cart and onto the ground, resulting in a fractured right hip.
More severe injuries in KANSAS
WATHENA, KANSAS—
Omya Inc.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
COFFEYVILLE, KANSAS—
John Deere Coffeyville Works
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
HAVEN, KANSAS—
Haven Steel Products Inc
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
MINNEOLA, KANSAS—
Vestas-American Wind Tech
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
MEADE, KANSAS—
Alliance Ag and Grain LLC
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.