Ignition of clothing from controlled heat source · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at Pall Aeropower Corporation, 10540 Ridge Road, NEW PORT RICHEY, FLORIDA 34654
on — Second degree heat (thermal) burns, affecting the hand(s) and arm(s), n.e.c..
Final narrative
An employee was brazing stainless steel when a spark contacted her shirt and set it on fire. The employee suffered second degree burns on her right hand and the inside of her right forearm.
HospitalizedHand(s) and arm(s), n.e.c.Blouses, shirts, dresses, trousers, skirts
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 333999)
An employee was working on an assembly line in the production facility. He was on the south part of the aisle, checking for debris in the system, and went to remove a screw. His left foot became caught in a wheel on a track along the assembly line. All of the toes on his left foot were amputated.
A maintenance employee was using an air wand to clean equipment. The air wand became caught in the rollers that were turning and the employee's left arm was pulled into the equipment. Their arm was crushed to the elbow and the fifth digit on their left hand was amputated.
On July 3, 2024, at approximately 8:00 AM, an employee was installing a pulling sheave in an electrical gear when they received a high-voltage electrical shock and sustained arc flash burns.
An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.
An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.
An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.
An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.