Contact with objects and equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at United States Steel Corporation, 1951 State Street, GRANITE CITY, ILLINOIS 62040
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was completing a roll change. As he reached out to stop the movement of a roll chock coming down the incline, his left hand was pinched between two roll chocks. His index finger was amputated.
An employee was working with a mixer. The employee fell through a floor hole to a platform 20 feet below the mixer, suffering a fractured pelvis and fractured vertebrae. The employee was hospitalized.
An employee was walking around a mortar dump box, using a water hose to clean debris out of it. The grating slid out of position and the employee's leg went into the sump water. He suffered second-degree burns to the leg.
Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.
Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.
An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.
More severe injuries in this industry (NAICS 331513)
An employee was unloading metal from two drums on a pallet. The employee removed the lid from the second drum and the drum fell over onto his ankle. The employee sustained a fractured ankle.
An employee was working with team members on the pouring line, casting a sand mold. Molten metal entered the employee's personal protection suit and severely burned his left leg, calf, and ankle.
An employee was jointing a board with a jointer. The board jumped when it came into contact with the jointer's cutter head, and the jolt caused the employee's left hand to slide between the board and the guard and come into contact with the cutter head. He suffered lacerations/partial amputations to the middle, ring, and index fingers.
An employee was turning off a gas valve when he bumped into a die brush and struck the spinning die. The die pin struck him on the back, resulting in contusions, abrasions, and a severe laceration to his back that required hospitalization and surgery.
At 11:45 a.m. on June 13, 2025, an employee of Staley Steel, LLC, was performing preventive maintenance on an overhead crane. While he was holding a grease gun hose and nozzle, he contacted electrical components inside an electrical box. He suffered a first-degree electrical burn on the palm of the left hand, as well as pain up his left arm to the shoulder, and was hospitalized.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.