MADISON, WISCONSIN—
Crown Lift Trucks
Caught or wedged between objects nonrunning · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury at Crown Lift Trucks, Playcon, MADISON, WISCONSIN 53719 on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was manually moving a forklift battery in its compartment when her right index finger was pinched between the battery and the top of the compartment. The employee sustained a fingertip amputation.
More severe injuries at Crown Lift Trucks
NORTHLAKE, TEXAS—
Crown Lift Trucks
An employee was operating a lift truck when it struck a stationary lift truck. His left thumb was pinched between the two lift trucks, resulting in a partial amputation.
FAIRFIELD, OHIO—
Crown Lift Trucks
On June 6, 2025, an employee was performing maintenance on a vertically-stored dock leveler. After completing the hydraulic repair, the employee went to exit the work area when their pant leg got caught on the bumper of the dock leveler. This caused the employee to lose their balance and fall out of the open dock door, approximately 37.5 inches. The employee sustained a lower left leg fracture.
UNIVERSITY PARK, ILLINOIS—
Crown Lift Trucks
On April 30, 2024, while at a customer location loading equipment onto a flatbed trailer for transport, an employee was injured when the trailer settled downward and pinched the employee's left foot between the equipment being loaded and the dock plate. The foot was fractured.
ARDMORE, OKLAHOMA—
Crown Lift Trucks
An employee was installing a dock leveler at a customer location. Cardboard was under the plate and a pry bar was used to lift the dock plate to remove the cardboard. The pry bar shifted and the dock plate fell on the employee's left ring and middle fingertips resulting in amputations.
NORTHLAKE, TEXAS—
Crown Lift Trucks
On September 25, 2023, a forklift maintenance technician was removing a fork from the lift truck when the fork slipped from the employee's grip. His finger was pinched between the fork and the carriage, resulting in an amputation of the right ring finger just below the nail.
View Crown Lift Trucks's full OSHA safety record →
Similar incidents · Same event type
KEWANEE, ILLINOIS—
Great Dane Ltd. Partnership
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
JEROME, IDAHO—
Milk Specialties Global
An employee was diagnosing the lack of flow of product to a powder bin. The employee removed the rotary star valve below the bin. While he was reinstalling the valve, his right middle finger was crushed between its shaft and its housing. The finger was partially amputated.
LIMA, OHIO—
GXO Logistics
On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.
LANCASTER, PENNSYLVANIA—
Zimmerman & Herr
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
PROCTOR, WEST VIRGINIA—
Certainteed Gypsum West Virginia, Inc
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
More severe injuries in this industry (NAICS 423830)
MIDLAND, TEXAS—
TRC Services of Texas INC
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
DEER PARK, TEXAS—
Onpoint Industrial Services Hiring Center
An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.
TULSA, OKLAHOMA—
S&R Compression, LLC
A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.
GIRARD, OHIO—
Morgan Engineering Systems, Inc
An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.
NORTH CHARLESTON, SOUTH CAROLINA—
Fairbanks Morse, LLC
A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.