Fall to lower level from collapsing structure or equipment more than 30 feet · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at IEA Constructors, Cimarron Bend Wind Farm Project LLC, MINNEOLA, KANSAS 67865
on — Fractures , affecting the Multiple body parts n.e.c..
Final narrative
An employee was descending a suspended scaffold after performing repairs on a wind turbine blade. The scaffold malfunctioned and the employee began accelerating; he did not free fall, but fell approximately 90 feet to the ground below. The employee sustained fractures to the spine, back, hip, and legs.
Hospitalized Multiple body parts n.e.c. Suspended or hanging scaffolds or staging
An employee was installing metal panels on a roof when they fell through a skylight and landed on the ground 40 feet below. The employee sustained injuries to their head and ribs.
Employees were installing components of an elevator from inside the elevator and removed temporary hoisting equipment when the elevator descended from the fourth floor to the pit floor. One employee was hospitalized with fractures to their fibula and a rib, and the other employee was hospitalized with fractures to both feet.
An employee was descending after trimming up in a tree when the limb that his climb line was attached to failed after he descended 7 feet. The employee fell approximately 30 feet to the ground. The employee sustained three fractured vertebrae and a fractured sternum.
An employee was working 32 feet above the ground in a scissor lift, attaching a camera to a gantry crane. The crane moved and struck the scissor lift, which tipped and fell to the ground. The employee was hospitalized with fractures to his collarbone, humerus, and pelvis. Fall protection was worn at the time.
An employee was descending the side of a scaffold when a rail detached from the scaffold and the employee fell 38 feet to the concrete ground. The employee sustained a fractured pelvis, fractured lumbar vertebra(e), and lacerations.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.