Other fall to lower level, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Builders First Source, 201 Parkridge, SOUTHLAKE, TEXAS 76092
on — Fractures, affecting the upper and lower limb(s).
Final narrative
An employee was climbing on a trailer to retrieve a hardware bag when the employee tripped and lost footing, falling off the trailer to the ground. The employee suffered fractures to the left wrist and left ankle.
An employee was measuring a block on a pedal-operated upcut saw equipped with a 10 or 12 inch circular blade. As he was taking a measurement, the blade contacted his left hand, resulting in amputations of three fingers.
Employees were stacking two different types of trusses in a yard. One employee was lifting one end of a truss with a forklift while another inserted a spreader block. The load shifted, and the second employee's left ring finger was pinched between the block and the trusses. The finger was amputated.
An employee had been installing door and inside trim at a location. The employee was cutting lumber with a chop saw and amputated his left middle and index fingers.
An employee was behind a truck, preparing to dump one of two pallets of lumber from the truck's dump body (which had been raised so the lumber could be unloaded). The other pallet slid off the truck and struck the employee's lower leg, breaking it.
An employee was unloading lumber from a railcar. Railcars have ladders welded to each side for employees to enter/exit. The employee was climbing down one of the railcar ladders and slipped and fell between 6 and 8 feet to the ground. The employee suffered a fractured back, dislocated shoulder, and laceration to the top of the head.
An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.
An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.
An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.